INSTRUCTIONS FOR THE USER
18
ATTENTION: Machine in conformity with the existing hygienic
standards, guaranteeing a final rinse at 85°C. Wash cycle automatically
lengthened if final rinse temperature is not reached.When this auto-cycle
intervenes and the cycle is pro-longed, after 8 minutes the "H3"
indicator flashes to indicate this intervention and the cycle continues
(water supply temperature is likely to be the problem, otherwise contact
an assistance center since it is a rinse water heating intervention.). Turn
off the machine to remove this alarm.
7. Remove the rack and slightly incline it to permit a perfect drain; allow
dishware to dry and after having washed one’s hands, handle the rack in
order not to touch the dishware inside then place the rack on hygienically
clean shelves.
8. With the machine off (by pressing the "Q1" switch), take out the overflow
pipe from the tank and wait until it is completely empty then close the door
and turn on the machine (by pressing the "Q1" switch) for a few minutes to
wash the machine. Then again press the switch "Q1" to turn off the machine
and wait until the tank is completely empty.
For machines with drain pump, open the front door, pull out the
overflow pipe, turn on the machine and press the "S3" button for the drain
cycle.
The machine will carry out the drain cycle ("H3" on) for 2 minutes and 20
seconds.
At this point, the tank filter can be taken out, in order to be washed, then
replace it with the overflow in its place.
(For further use , first switch off the machine).
For any further information concerning equipment cleaning, read chapter
"USEFUL SUGGESTIONS".
9. When the washing is finished, switch off the equipment by turning off
the main supply through the general wall switch and close the water
supply.
To Next Page
Loading...