To Next PageTo Next Page
Need help?Do you have a question about the Wet Labs ECO FL and is the answer not in the manual?
General| Brand | Wet Labs |
|---|---|
| Model | ECO FL |
| Category | Measuring Instruments |
| Language | English |
Policy for returning instruments with anti-fouling treatment, specifying what is not accepted.
Guidelines for properly packaging and shipping instruments for service or repair.
Details technical specifications for various ECO fluorometer models.
Describes the six-pin bulkhead connector and specific connectors for FLB/FLSB models.
Lists standard items included with the ECO fluorometer delivery.
Outlines available optional accessories for the ECO fluorometer.
Details the second bulkhead connector specific to ECO FLB and FLSB models.
Description of the optional test cable and its components.
Information on optional copper faceplates for improved biofouling resistance.
Details integrated anti-fouling Bio-wiper and copper faceplate for extended deployments.
Discusses internal battery options (Lithium, alkaline) and their capacities.
Explains the optional external thermistor and how to use its calibration equation.
Details the optional pressure sensor, calibration, and how to calculate absolute pressure.
Provides instructions for maintaining the pressure sensor and its silicone oil buffer.
Guides on performing initial electrical checkout and safety notes for UV LEDs.
Instructions for connecting a multimeter to the analog output for testing.
Details on powering the sensor, using the fluorescent stick for testing, and handling AC light interference.
Explains the function and operation of the anti-fouling Bio-wiper for optical surface protection.
Provides guidelines and warnings for deploying the ECO meter.
Recommends factory maintenance and provides basic sensor cleaning instructions.
Steps for removing, cleaning, and re-installing the Bio-wiper and faceplate.
Detailed procedure for safely removing the end flange and replacing internal batteries.
Step-by-step guide for reassembling the end flange and securing the battery pack.
Instructions for cleaning and replacing O-rings on the vent plug.
Explains how scale factors are calculated for chlorophyll and other measurements.
Discusses linearity and calibration procedures for analog output signals.
Describes how digital data is processed, scaled, and calibrated.
Defines dark counts and how they are measured as a baseline.
Details the wet hyperbaric test to ensure housing and seal integrity.
Describes the test for mechanical stability involving vibration and shock.
Explains how electronic stability is computed over extended periods.
Defines noise measurement based on standard deviation of samples.
Outlines tests for verifying correct voltage range operation and current draw.
Lists the baud rate, data bits, parity, stop bits, and flow control for terminal communication.
Provides a list of commands for controlling the ECO sensor via a terminal emulator.
Defines the first line of the device file used as a plot header in ECOView.
Explains the format for specifying the number of data columns in a device file.
Details how each output column is described in the device file.
Lists valid column descriptions for fluorescence measurements like CHL, IENGR, etc.
Lists valid column descriptions for miscellaneous data like date, time, and unused columns.
Provides an example of a device file without engineering output for an ECO FL.
Presents sample output files for ECO chlorophyll fluorometers with and without external thermistors.
Sample output file for firmware versions 3.01 and higher with optional thermistor.
Sample output file for firmware versions prior to 3.01 with and without external thermistor.
Details the procedure for arranging the return of an end-of-life WEEE product.
