Function instruction
For more information please refer to the WFLY official website
HELI
SYS SETTING
1.MODEL SELECTTING
2.MODEL SETTING
3.TRAIN./SIMU
4.STICK SETTING
5.ADJUSTMENT
6.REST SETTING
7.SOUND
8.CONTRAST SETTING
9.BATTERY
10.ABOUT
NORMAL SETTING
1.MONITOR
2.DUAL RATE&EXPONENTAIL SETTING
3.SERVO REVERSE
4.END POINT
5.SUB TRIM
6.TRIM STEP SETTING
7.TROTHROTTLE CURVE SETTING
8.PITCH CURVE SETTING
9.THROTTLE CUT SETTING
10.TROTTLE HOLDING SETTING
11.TIMER
12. SWASH
13.GYRO SENS SETTING
14.ADVANCED
1.GOVERNOR MIXING
2.PROG.MIX1-2-3
3.FAIL SAFE
4.CODING
ACRO
NORMAL SETTING
7. FLAPERON
8. FLAP TRIM
9. AIL-DIFF
10.ELEV-FLAP
15.ADVANCED
1.ELEVON
2.AILVATOR
3.V-TAIL
4.AIL-2
Set a good save multiple sets of parameters, any switch when needed.
Helicopter or fixed-wing selection.
Training or simulator functions selection.
Joystick operation mode selection.
Recovery model parameters currently used.
Select the buzzer turned on or off.
Adjust the screen contrast ratio.
Select the correct battery type, can extend the battery life.
Display version information.
Observe status of each channel output.
Set the direction of the positive and negative steering.
Set servo travel distance.
Adjust the servo neutral point position.
Adjust the position of the servo endpoint.
Adjust the throttle output linear relationship.
Adjust the output linear relationship of pitch.
Set the alarm time of flight, help remind the battery or fuel capacity.
Select the type of helicopter swashplate.
Adjust the sensitivity of the gyroscope in different flight modes.
Pacer special adjustment.
Hybrid control any two channels' output.
The transmitter and receiver match.
Regulating flap and aileron linkage.
Adjust aileron and aileron differential.
Adjust the elevator and flap-way mixing.
Aileron and elevator combination of aircraft mixing settings
Adjust the elevator and aileron unidirectional mixing.
Adjust the elevator and rudder mixing.
Another aileron channel allocation.
When flight completed can make the engine timely stall, often for electrical
straight flameout landing.
Lock output state of the throttle, the engine idling. Commonly used in the oil machine
flameout landing.
Action curve adjustment for each channel, changing the feel and sensitivity of each
channel.
Adjust the neutral point or highest/lowest point of AIL,ELE,THR and DIR channel.
When the receiver loss of signal, each channel will automatically return to the preset
position.
Adjust flap total stroke alone change the flaperon channel, mixing synchronized.
9
To Next Page
Loading...
