Hand tighten cocking rod to ensure proper
function of your marker. This might become
loose after some use
B
e sure not to cross threAd.
VI. TROUbLESHOOTING
3. Marker will not fire when trigger is pulled.
• Gas source pressure low or tank empty. Fill tank.
• Make sure the hole in your bolt, between the 2 o-rings is facing down.
• Make sure battery is installed, and has a good charge.
4. Marker will not cock or cocks every other time or less.
• Pressure too low. Fill tank.
• Velocity adjustment set too high.
• Back block or cocking rod adjustment incorrect.
To Next Page
Loading...