Need help?Do you have a question about the Whirlpool Ariel HW 123 and is the answer not in the manual?
Ensure adult supervision for children; be aware of drowning risks and long hair entanglement in suction ports.
Consult a doctor before use if pregnant, using medication, or with pre-existing health conditions like heart problems.
Avoid excessive use to prevent heatstroke; use electrical protection devices and avoid other electrical devices nearby.
Damaged wires, cords, or plumbing must be repaired by a qualified professional. Check local codes before purchase.
Do not lift by critical parts; install with accessible components. Ensure good ventilation to prevent moisture damage.
Verify compatibility of electrical, water, and waste lines. Flush water lines and ensure dedicated shutoff valves.
Follow manual steps for correct installation. Use a professional electrician for electrical work and ensure proper grounding.
Do not disassemble controls. Keep electrical components away from the bath. Use GFCI/RCD protection.
Ensure correct hot/cold water connections. Avoid harsh chemicals like acetone, ammonia, or gasoline.
Inspect power cables and all connections. Clean the unit thoroughly inside and out before initial use.
Operate the system for 10 minutes, let it sit, and check for leaks. Test all functions to ensure proper operation.
Avoid using bath oils as residue can stick to tub walls and plumbing, causing issues.
Familiarize yourself with the Power Standby, Light, Air Bubble, Music, Heat Pump, and Water Jet buttons.
Turn the system on/off via Power Standby. The system has a 2-hour auto-off timer.
Water jets activate when the water level is above the sensor. Default operation time is 20 minutes.
Adjust underwater light color (C=1 to C=7) and brightness (B=1 to B=3) using dedicated buttons.
Heatpump activates with water jets and sufficient water level. Set temperature between 35-43°C.
Operate FM radio or Bluetooth. Pair devices using 'Whirlpool' and password '1234'.
Activate Air Bubble feature. It turns off automatically after 20 minutes or if water level drops.
The air bubble feature runs for 1 minute to flush and dry air jets after water level is no longer detected.
Operate the selector valve (waterfall, shower, jets) and temperature valve (hot/cold).
This valve controls the amount of air bubbles in the Water Jet feature.
Clean drains, avoid abrasive cleaners on chrome, use mild detergent on acrylic, and consider monthly cleaning solutions.
Details on rated voltage, current, power, frequency, and waterproof level (IPX5).
Specifications for water pump, heater pump, air pump, lighting, and speaker power and voltage.
Requirements for water/electrical connection, pressure, and GFCI/RCD usage. Max hot water temp is 80°C.
General| Brand | Whirlpool |
|---|---|
| Model | Ariel HW 123 |
| Category | Bathroom Fixtures |
| Language | English |
To Next Page