OPERATION
Stay Alert Feature
The Stay Alert Feature is designed to test a driver’s alertness.
To engage (when the unit is not alarming) :
• Press and hold the City button for approximately 2
seconds. Release the button during or immediately after
the alert is given.
Display Shows:
Within 30-60 seconds, two beeps are sounded; to
show alertness, the driver must press either the City, Menu,
or Quiet buttons within 3-5 seconds. If a button is pressed
within 3-5 seconds, the cycle is repeated.
If a button is not pressed within 3-5 seconds, an alarm
sounds.
Display Shows:
• Press the Dark button to exit the Stay Alert feature.
WARNING!!! Stay Alert is NOT intended as a substitute for
adequate rest. You should NOT operate a vehicle if
you are
drowsy. During extended periods of vehicle operation, you
should take frequent breaks. Improper reliance on the Stay
Alert feature may result in vehicle damage, personal injury
or death.
VG-2 Detection Mode
See Option Select Mode to turn this feature on/off. When a
VG-2 signal is detected, the VG-2 alert is sounded and the
display flashes “VG-2”. After 3 seconds the audio is canceled
and the display no longer flashes. This cycle is repeated if
the VG-2 signal is detected again .
During the period a VG-2 signal is detected, a radar
signal cannot be detected.
However, because the VG-2 alert has confirmed that a patrol
car is nearby, you are already aware of the potential for
speed monitoring and can adjust your speed accordingly.
Laser detection is not affected while a VG-2 signal is
detected.
To Next Page
Loading...
Need help?
General
