This product must be installed by a qualified heating and air conditioning contractor.
Failure to do so could result in serious injury from electrical shock.
installation Options _ hum_d_fie_s.o_dnot_ _nste,edwbe_t_pe,_lu_aco_dex_o_480°F,
Model HFT2700 Installation Instructions and Mounti "Template
iB.
Y
A. Mourn the humidifierio'_he CI
warm alr pMnum. Connect the
unit to the cold air mtum using 6"
round duct.
OR
B. Mount the humidifier to the I
coM e_r return. Contact the un_
to the warm air duct using 6"
round duct,
C. The White-Rodg_rs Model
HFT2700 should be Ins_led as
shov_ in re_atton to AC cooling
co_s.
Installation
4.a
0
1. Tape the template onto the
tumace ptenum, making sure
it ts lever,
T_acothe four sides onto the
ptenum.
Remove the template from the
plenum.Accurately cut the
ptenum opening.
instructions
Caution Template Must Be Level
2. Disengage the hum_fitier
Coverf_om the m,ouot[ngframe by
rotating the _umb screw lecated at
the bottom of the cover. Tilt and lift
the cov_ off the f_ne.
Pul_out lhe ddp traV Grid _aporater
pad assembly by gr_ping the top
_p end tipping out.
3. The humidifieris assembled
for right side disc_rge_To convert
from rlght In left side discharge,
applypressuretotheinsideo_
the side panel using both hands
as thechows indica_{ein the above
iltustraliun and [if[ out. Exchange
the two side pieces and reinstall
us}ng moderate pressure.
4. Place the mounting frame
_nto the plenum opening so
that the trams hooks over the
bottom ot the cut-out plenum
opening, Screw the frame to the
plenum with the screws provided.
5, Reinstall lhe evapo,_tor pad
end ddp tra__,.
Reattach the cover assembly
bv hooking _tat the top of the
mounting trams first, then
securing with thumb screw a_.
the bottom.
C
In
O
To Next Page
Need help?
General
