8
Step 3. Tighten wing nuts.
Step 4. Raise complete handle assembly until it clicks
into place. Make sure not to kink the control cables.
Step 5. Pinch lower handle against mounting bracket
with pliers.
Step 6. Move hairpin clip from outer to inner hole on
left and right handle mounting brackets.
Step 7. Attach control cables to handle with cable ties
located on the handle.
Step 8. Squeeze the blade control handle against the upper handle and pull out starter rope slowly.
Step 9. Thread starter rope into rope guide.
HERE
Handle
Assembly
Pinch Here
Hairpin Clip
Inner Hole
HERE
Blade Control Handle
Upper Handle
Starter Rope
Look here
Rope Guide
for rope guide
Squeeze handle
NOTE:
Your mower has been shipped with the deck and casters set in the lowest cutting position.
Please see “cutting height adjustment” in the ADJUSTMENTS section of this manual to adjust the cutting height.
To Next Page
