why pro WHY-EP - Special Procedures; Reactivating Rolling SICE TECH Code; Maintaining Serial Number of Rolling Remote; Programming Rolling Code with Serial Number

To Next Page

To Previous Page

SPECIAL PROCEDURES

TO REACTIVATE THE ROLLING SICE TECH CODE INSERTED AS DEFAULT ON A

BUTTON, PROCEED AS HERE BELOW:

1. While pressing the button 1 of the WHY-EP, at the same time press 4 times the 2 button.

2. Release both buttons. Now the WHITE LED “WHY-EP” will emit a short ﬂash every 2 seconds.

3. Press the button where you want to reactivate the rolling code and retain pressed till the LED switches o.

NOTES:

TO reactivate further buttons of WHY-EP, please repeat the operation form the step 1.

TO MAINTAIN THE SAME SERIAL NUMBER OF A ROLLING REMOTE

1. While pressing the button 2 of the WHY-EP, at the same time press 4 times the 2 button.

2. Release both buttons. Now the LED “WHY-EP” will emit a short ﬂash every 2 seconds.

3. Place the original remote control to be programmed in front of the “WHY-EP”, at about 5 cm of distance (as shown in

the picture at the page 3).

4. Press and retain pressed the 1 button of the original remote control and wait for a change of color of “WHY-EP” LED

that it will switch o.

5. Choice the button where you want to program the freqeucny and press it. This step may take some seconds.

6. The copy has been happened.

7. Activate now the correct procedure for the copied model and insert the new remote control on the receiver (see the

compatibility list present in this manual).

8. Repeat this procedure for the other buttons, if necessary.

PROGRAM A ROLLING CODE ON EACH BUTTON WITH A SERIAL NUMBER

1. While pressing the button 4 of the WHY-EP, at the same time press 4 times the 1 button.