WWW.WIDDERTOOLS.COM® 3
(203)777-5395
OPERATING INSTRUCTIONS:
Warning: Operator should be thoroughly familiar with safety precautions before
attempting to operate this tool.
1. Install saw blade firmly with Lock plate and pin engaged with blade.
2. Be sure saw is firmly mounted on WIDDER® Pipe Clamp. Close needle valve.
3. Start power source.
4. Adjust needle valve to desired speed.
5. Manually feed blade into cut, applying enough pressure to produce chips shaped like
small 6 or 9 shaped pieces. Adjust saw speed to compensate for load if required.
6. If possible, apply lubricant, water, or air blast to cut. This will extend blade life, speed
cutting time, and keep the blade and work piece cool.
7. CAUTION: No steel cutting blade can cut without the chance of heat or sparks. Do
not use tool in explosive environments without following all industry accepted practices
for safe power tool and metal working operation.
To Next Page
Loading...