105
Please have your model number and the last 7 digits of your VIN# ready when you call for parts.
Have a problem - Need parts - Please call Toll Free (866) 658-7300 • Email: parts@wildfiremotors.com
Please have your model number and the last 7 digits of your VIN# ready when you call for parts.
Have a problem - Need parts - Please call Toll Free (866) 658-7300 • Email: parts@wildfiremotors.com
Control Functions
Odometer
•
The total riding distance is indicated.
Fuel gauge
• The gauge indicates how much fuel is in the tank (the gauge does not work
when the ignition switch is off). The needle moves from full "F" to empty "E" as
your fuel decreases. Fill the tank with a good grade of 89-93 octane
unleaded gasoline.
Turn Signal Indication Light
• The turn signals indicate that you are turning a chosen direction, push the button
in the desired turning direction, it will return to the center, press the button in to
turn off.
Speedometer
Odometer
Turn Signal
Switch
Fuel Gauge
Turn Signal
Indication Light
Turn Signal
Indication Light
High Beam
Indication Light
High Beam
Switch
Horn
Engine Kill
Switch
Headlight
Switch
Trip Odometer
Start Button
Check before Riding
• Check throttle and make sure it turns smoothly.
• Make sure the brakes work properly and adjust if necessary.
• Check bolts for tightness.
• Make sure there is plenty of fuel.
• Check tire pressure.
• Check all of the lights, headlight, taillight, turn signal etc.
• Check the engine oil.
Starting Off, Riding, Stopping and Parking
Before starting, put the side stand up.
(1).Turn the key to the on position.
(2).Apply the rear brake.
(3).With the throttle at idle position push the electric start button or use the kick start: if the
engine fails to start turn and release the throttle then push the electric start button or
kick start again. Be sure and replace the kick starter to its original position before riding.
(4).If the bike is on the center stand hold the handle bars with both hands and push forward, if
the bike is on the kick stand hold the bike up and push the kick stand with your foot.
(5).For a cold engine, let the engine idle for 1-3 minutes before riding.
(6).Sit on the bike keeping one foot on the ground for stability, release the brake and twist the
throttle to accelerate, after you start to accelerate put both feet on the foot rest only
putting them on the ground when coming to a stop.
(7).When coming to a stop decrease your speed by releasing the throttle and apply both
of the brakes, if the front tire begins to skid release and reapply.
(8).Parking: Turn the handlebars to the left as far as they will turn, then put the key in
the lock position (this will lock the steering, remove the key, to avoid theft.) Put your
kick stand down or use the center stand.
NOTE: The muffler and exhaust pipe are hot. Park away from pedestrians.
(9). Practice in an empty parking lot or driveway until you feel confident enough to ride on
the street.
(10). When preparing to ride on a street make sure the headlights are on, check for
traffic and use your turn signals at all times remember to turn the signals off after use.
(11). Always remember to obey your local and state laws and regulations.
(12).Remember, always wear safety gear.
To Next Page
Loading...
