safety control switches guarantee the operator safely.
21. 0~30s electronic control timer allows you to control the powder amount, one, two or more cups, at
your will.
22. 0~252˚ rotary bean cup allows you to adjust the thickness of powder optionally to obtain each kind of
coffee powder that available for any coffee machine.
23. The power cord is concealed under the unit body.
24. This product produces little noise and vibration during operation, it is also equipped with motor
overload protection mechanism.
Suitable purpose of coarse and fine powder and degree setting:
Coarse French Press 50g~90g/30s
Medium Drip type coffee maker 40g~70g/30s
Fine Espresso 20g~60g/30s
Operation Instruction:
1:The product is simple in operation and safe. Please do test running before using:
19. Put the grinding disc “D” on the grinding head inside
the main body “E” to cover the grinding head, then
align the two latches to the groove flatly and turn on
with care.(See FIG.2)
20. Install the empty bean cup “B” carefully to the proper
position of main body “E” with the "0" position point
to the red thickness indicator "G" on the main body, and then turn rightward to the desired
thickness.(See FIG.3)
Note: Never turn leftward. If the bean cup is not turned rightward after installing into the main
body, the touch switch controlled by bean cup "B" will be off and the grinding machine will not
work.
21. Install the powder cup “F” to proper position in main body “E”.(See FIG.4)
22. Connect the power cord “C” to the socket in proper
voltage, and enable the socket.
23. Rotate the timer knob “I” to the desired position
(depends on the required powder volume).
24. turn on the touch switch "H" gently to start the grinding machine
Note: Press once to turn on the machine and again to turn off; when any bean cup control inching
switch "B", powder cup control inching switch "K" is turned off and turned on again, or the timer
knob "I" is turned to "0" and rotated again, it is required to turn on the touch switch "H" again
before starting the grinding machine.
2: When the system is verified to be functional after the above operations, you can start grinding the
coffee beans:
13. Turn off the power switch to leave the coffee machine under idle status, and then rotate the bean
cup“B” (see FIG.3) and set the desired degree.cup“B” (see FIG.3) and set the desired degree.
14. Fill the bean cup “B” with an amount of coffee bean and close cover “A”. (about 250g when fully
filled)
15. Turn the timer knob “I” to desired time. (control the grinding time to obtain desired grinding volume)
16. a. If you use the powder cup "F" to store the powder, please turn on power switch "L" and turn on the
touch switch "H" gently, the grinding machine will start working.(See FIG.4)
Alarm:
1. Never put coffee bean into the bean cup until the cup is fully seated.
2. Please adjust the grinding thickness before filling coffee bean.
3. Never take out bean cup until grinding finished.
4. After grinding, please turn the bean cup leftward to "0" before taking out the bean cup and grinding
disc for cleaning. Do revert after cleaning.
To Next Page
Loading...
