Wilfa Narvik 25 - Operating the Air Conditioner; Remote Control Battery Replacement

24
EN
INSTRUCTION MANUAL · AIR CONDITIONER
CHILDLOCK FUNCTION
Press ”p” and ”q” simultaneously to turn on or turn off child lock function.
When child lock function is on, ” ” icon is displayed on remote controller. If
you operate the remote controller, the ” ” icon will blink three times without
sending signal to the unit.
TEMPERATURE DISPLAY SWITCHOVER FUNCTION
Under OFF status, press ”q” and ”MODE” buttons simultaneously to switch
temperature display between °C and °F .
WIFI FUNCTION
Press the WIFI button to activate the function. Press again to stop the function.
More info can be found in WIFI attachments and wilfa.no, wilfa.com
OPERATION GUIDE
1. After putting through the power, press ”ON/OFF” button on remote
controller to turn on the air conditioner.
2. Press ”MODE” button to select your required mode: AUTO, COOL, DRY,
FAN, HEAT.
3. Press ”p” or ”q” button to set your required temperature. (Temperature
can’t be adjusted under auto mode).
4. Press ”FAN” button to set your required fan speed: auto, low, medium and
high speed.
5. Press ”SWING” button to select fan blowing angle.
REPLACEMENT OF BATTERIES IN REMOTE
CONTROLLER
1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make
sure the position of “+” polar and “-” polar are
correct.
3. Reinstall the cover of battery box.
NOTE
• During operation, point the remote control signal sender at the receiving
window on indoor unit.
• The distance between signal sender and receiving window should be no more
than 8m, and there should be no obstacles between them.
Reinstall
Remove
Battery
Cover of battery box