13
© Wilks-USA
Hedge Trimmer
1. Pour fuel into the fuel tank and tighten the cap securely.
2. Rest the unit on a flat, firm place. Keep the cutting head off the
ground and clear of surrounding objects as it will start moving upon
starting of the engine.
3. Push the primer several times until overflown fuel flows out in
the clear tube.
4. When the engine is cool, move the choke lever to the closed
position.
5. Set the ignition switch to the “RUN” position. Release the throttle
trigger and make sure it is fully back.
6. While holding the unit firmly, pull out the starter rope quickly
until engine fires.
• Avoid pulling the rope to its end or returning it by releasing the
knob. Such actions can cause starter failures.
7. Move the choke lever downward to open the choke. and
restart engine.
8. Allow the engine to warm up for a several minutes before starting
opertion.
Note:
1. When restarting the engine immediately after stop- ping it, leave the
choke open.
2. Overchoking can make the engine hard to start due to excess fuel.
When the engine failed to start after several attempts, open the choke and repeat pulling the
rope, or remove the spark plug and dry it.
1. Release the throttle trigger and run the engine for half a minute.
2. Shift the stop switch to the “STOP” position.
Except for an emergency, avoid stopping the engine while pulling the
throttle trigger.
Note: If the engine won’t stop when setting the stop switch to the stop
position, close the choke lever and stop the engine. In this case, please
repair the machine at your nearest servicing dealer.
Operation
Starting the engine
Stopping the engine
To Next Page
Loading...