15
© Wilks-USA
Hedge Trimmer
Horizontal cut:
• In order to get the best cutting results, slightly tilt the blade (5°-10°) towards the cutting
direction. Cut slowly, especially with thick hedges.
Always follow the safety precautions.
The hedge-trimmer must only be used to trim hedges or small
bushes. It is forbidden to cut other types of material. Do not use the
hedge-trimmer as a lever to lift, move or break objects, nor lock it on
fixed supports. It is forbidden to apply tools or applications that are
not the ones indicated by the manufacturer onto the hedge-trimmer’s
power take-off. Do not use it for pruning trees or cutting grass.
Operation
Cutting work
Maintenance
System/
Components
Procedure Before
use
Every 25
hours
after use
Every 50
hours
after use
Every 100
hours
after use
Note
Engine
Fuel leaks, fuel
spillage
Wipe out
✓
Fuel tank, aur
filter, fuel filter
Inspect/
Clean
✓ ✓
Replace if
necessary
Idle adjusting
screw
See
adjusting
idling speed
✓
Replace
carburetor if
necessary
Spark plug Clean and
readjust
plug gap
✓
Gap:
0.6~0.7mm
replace if
necessary
Intake air
cooling vent
Clean
✓
Trimmer
Throttle trigger,
stop switch
Check
operation
✓
Cutting parts Clean
✓
Take it to a
service dealer
if something is
wrong
Gear case Grease
✓
Screws/ Nuts,
Bolts
Tighten/
replace
✓ ✓
Not adjusting
screws
Plate receive Make sure
to attach
✓
To Next Page
Loading...