18
© Wilks-USA
Hedge Trimmer
• Note that using any spark plug other than those designated
may result in the engine failing to operate properly or engine
overheating causing damage.
• To install the spark plug, first turn the plug until it is finger
tight, then tighten it a quarter turn more with a socket wrench.
• Starting failure and misfiring are often caused by a dirty
spark plug. Clean the spark plug and check that the plug gap is
correct.
• Apply multi-purpose grease at every 50 hours of use.
1. Use a grease pump.
2. Feed grease until it comes out of the base of blades.
• The normal play is 1 or 2 mm when measured at the carburetor
side end. Readjust with the cable adjuster as required and tighten the
screw up.
(1) Cable adjuster
(2) 0.04in (1~2mm)
(3) Screw
The carburetor has been adjusted at the factory. Should your unit
need readjustment due to the changes in altitude or operating
conditions, please let your skillful dealer make the adjustment. A
wrong adjustment may cause damage to your unit.
(1) Idle adjusting screw
(2) Up
(3) Down
(4) Fuel adjusting screw (Opening 1 ± 1/4)
(5) Decrease
(6) Increase
(1)
Maintenance
Spark plug
Gear case
Adjusting throttle cable
Adjusting carburettor
To Next Page
Loading...