19
© Wilks-USA
Hedge Trimmer
1. Oil the blade to prevent rust.
2. Empty the fuel tank and put the cap back on.
3. Remove the spark plug, pour a small amount of oil into the cylinder.
4. Rotate the crankshaft several times using the starting rope in order to distribute the oil.
Put the spark plug back in.
5. Wrap the engine with a plastic sheet.
6. Store the trimmer indoors in a dry place, dust free place, out of the reach of children,
preferably not in direct contact with the floor and away from heat sources.
• When you dispose of the machine, do not disassemble the machine.
• When you dispose of the machine fuel oil, be sure to follow your local regulations.
Check Probable causes Action
Fuel tank Incorrect fuel Drain it and use correct fuel
Fuel filter Fuel filter is clogged Clean
Carburetor adjustment screw Out of normal range Adjust to normal range
Sparking (No spark) Spark plug is fouled/ wet Clean/ dry
Plug gap is incorrect Correct (GAP: 0.6~0.7mm)
Spark plug Disconnected Retighten
Check Probable causes Action
Fuel tank Incorrect fuel or staled fuel Drain it and use correct fuel
Carburetor adjustment screw Out of normal range Adjust to normal range
Muffler, cylinder (exhaust port) Carbon is built-up Consult with the repair specialty
store
Air cleaner Clogged with dust Wash
Cylinder fin, fan cover Clogged with dust Consult with the repair specialty
store
Case 1. Starting failure
Case 2. Engine starts but does not keep running/ hard restarting
Storage
Disposal
Troubleshooting guide
To Next Page
Loading...