Wilo DrainLift XS-F - Maintenance and Cleaning

English
Installation and operating instructions Wilo-DrainLift XS-F 31
8 Commissioning
•Plug in the safety plug
• On initial use, flush the toilet twice
• Check all pipe connections for leaks and tighten the clips if necessary
• Adjust the cistern of the toilet so that the flush volume is not less than 6 litres of water
Operation
NOTE: After using mild, commercially available detergents, flush several times so that no
traces of the cleaning agent are left in the unit.
CAUTION! Risk of damage!
The unit can be damaged by incorrectly fastened toilet cleaners.
Fasten holders for toilet cleaners very securely to the toilet bowl to ensure that they
are not flushed into the unit.
9 Maintenance and cleaning
Maintenance and repairs may only be carried out by qualified personnel
WARNING! Risk of infection!
All maintenance must be carried out wearing suitable safety clothing (gloves) in order
to prevent the risk of infection.
DANGER! Risk of fatal injury!
There is a risk of fatal electric shock when working on electrical equipment.
• Before all maintenance and repair work, switch off the unit from the power supply and
make sure it cannot be switched on by unauthorised persons.
• Disconnect the power plug!
• Work on the electrical part of the unit may only be carried out by a qualified electrician.
Fig. 20: Installing the unit
Place the unit in the room where it is to be installed, line it up
and fit the hanger bolt for buoyancy protection. Then fit the
connecting sleeves to the tank ports using the clips. Fit the
discharge elbow between the pressure pipe and the pressure
outlet of the unit and fasten it with the clips (Fig. 20).
Make sure all clip connections they are correctly seated and
do not leak.
Fig. 21: Prohibited substances
Attach the sticker warning of prohibited substances
(Fig. 21).
Attach the sticker supplied showing instructions (symbols)
for the user of the toilet somewhere clearly visible, for
example above the toilet lid or on the inside of the toilet lid.
CAUTION! Risk of damage!
Putting in prohibited materials can cause mal-
functions, damage the unit and invalidate the
warranty.
4
5
3
12