Window Master WSC 204 User Manual

DK
+45 4567 0300
info.dk@windowmaster.com
UK & IE
+44 (0) 1536 510990
info@windowmaster.co.uk
DE
+49 (0) 5221 6940 -500 Vertrieb / -650 Technik
info@windowmaster.de
CH
+41 (0) 62 289 22 22
info@windowmaster.ch
www.windowmaster.com
Other markets
+45 4567 0300
info@windowmaster.com
WSC 204 0102 / WSC 204MH 0102 / WSC 204BZ 0102 / WSC 204KP 0102 install 1606-UK ©WindowMaster 2011, 2016 ®WindowMaster is a registered trademark used under licence by WindowMaster Group
WSC 204
(WSC 204 0102 / WSC 204MH 0102 / WSC 204KP 0102 / WSC 204BZ 0102)
Smoke control panel
Operating manual / Technical information
WSC 204 0102 – WSC 204BZ 0102
plastic housing
WSC 204KP 0102
plastic housing with integrated break glass unit
WSC 204MH 0102 steel housing
Mitglied im
Fach kreis
el ektrom oto ris ch
be triebene
Rauc h- u nd Wärme-
ab zugs anl agen

Window Master WSC 204 Specifications

General

Type	Control Panel
Model	WSC 204
Input Voltage	24 VDC
Output Voltage	24 VDC
IP Rating	IP20

Summary

1. Safety information

2. Technical description

4. Function description

4.1. Smoke and heat extraction

Explains system response to smoke/heat and break glass activation.

4.4. Connection possibilities

4.7. Operation/ Setting possibilities

Describes how to operate the system and configure settings via slide switches and LEDs.

5. Installation

8. Wiring diagram

8.1. Standard wiring diagram

Illustrates the typical wiring connections for the WSC 204 smoke control panel.

8.2. Wiring diagram WSC 204KP

Shows specific wiring for the WSC 204KP model with an additional break glass unit.

8.3. Various wiring diagrams

9. Commissioning and troubleshooting

1) The control panel is completely installed, without the operating voltage applied

Checks for mechanical, electrical, and component integrity before applying power.

3) With mains voltage, with accumulator

Details battery connection and system state verification with mains and backup power.

4) Ventilation keypad

5) Break glass unit, primary

Tests the primary break glass unit and its effect on actuators and alarms.

7) Automatic detectors

Tests the system's response to automatic smoke and heat detectors.

8) Emergency power supply test

10. Maintenance