Page 9For technical questions, please call 1-800-444-3353.Item 93454
20. Fasten Drawer Bottom to Drawer Pack Panel. Once
Drawers are fully assembled, verify that the inside tracks
along the Sliding Partition are pushed forward.
See Figure R, right.
21. Slide Drawers into tracks along Sliding Partition and insides
of the Legs. See Figure S, right.
22. Once all Drawers are inserted, tap Wood Pegs (10) and
Small Anvil Pegs (11) into desired holes on the Table Top.
See Figure T, right.
The Workbench is now fully assembled and ready for use.
Figure R
Figure S
Drawer Front
Panel (16)
Wood Pegs (10)
Small Anvil
Pegs (11)
Table
Top (1)
Figure T
SAFETYOPERATIONMAINTENANCE SETUP
To Next Page
