3
DISH NETWORK HYBRID
1 2 3 4 5 6 7 8
0 = UP
1 = DOWN
KEY
BELL TV
1 2 3 4 5 6 7 8
FIGURE 1
Hybrid Mode settings are for use in areas where the standard DISH Network settings fail to provide HD programming.
This model is PRESET for DIRECTV
®
receivers.
If you have a DISH Network® or BELL TV™ receiver, you must change
the numbered switches (see gures below).
IMPORTANT! Do not install this system in the rain,
or under any wet conditions. Moisture may affect
electronics and void your warranty!
1. For best performance and to reduce signal acquisition
time, park vehicle on a level surface; level the RV.
2. Select a level spot on your roof for installation.
WARNING: Level the base front to back and side to
side. If base is not level the antenna may require more
time to locate the correct satellite or may not locate the
correct satellite.
3. Ensure proper distance to other rooftop equipment is
maintained.
Be sure no roof-mounted equipment is blocking the sat-
ellite “line of sight”; see chart below.
Using this chart, determine the minimum distances to
other equipment.
OBSTRUCTION
UNIT BASE
2
3
4
5
TO CHANGE SWITCH SETTINGS FOR DISH
NETWORK. SIMPLY MOVE #4 & #7 TO DOWN
POSITION (#8 SHOULD REMAIN DOWN ALSO).
1 2 3 4 5 6 7 8
DIRECTV DISH NETWORK
FACTORY PRESET
DIRECTV SWITCH SETTINGS
1 2 3 4 5 6 7 8
Installing unit on roof of vehicle —
8”
10”
17.5”
32.5”
12”
43.5”
15”
25.0”
DISH Network Standard and HD —
110°, 119°, 129°
DISH Network Hybrid —
61.5°, 110°, 119°
DIRECTV Standard —
101°, 119° (will not receive HD on 110°
or any KA-band HD on 99° and 103°)
BELL Standard and HD —
82° and 91°
Programming Availability —
To Next Page
Loading...
