Select Test.
It will go through a number of
steps, then return to the screen
shown here with previous
information cleared.
If at any point it asks you to save,
select Save or Yes.
Reconnect the coaxial cable to the “Sat In” port on back of receiver. Now turn on
the antenna. Allow it 3–4 minutes to acquire satellites.
(If you have an In-Motion system, after the search routine is complete the system
will take another 6 minutes before going into “Sleep Mode”. Once it does, the unit
will be completely silent. Do not proceed to Step 6 until this has happened.)
Move over to select Check
Switch.
Check that there are no
checkmarks by SuperDISH or
Alternate.
Next, select Test again.
This time it will install the
SW64 switch. This SW64 switch
is a DISH receiver setting, not a
physical part.
When you see the SW64 as the
installed switch, the antenna is ready for use.
Mission Antenna 8
4
5
6
DISH Receiver Setup
To Next Page
Loading...
