Maintenance
2138−1/A2
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
1/ 4
Tool: Key to Illustrations:
1
Tool box 94720C 1 Cylinder liner 13 4/2-way solenoid valve
with fittings for charging 2 Lubricating pump 14 Sink plunger
accumulator 3 Accumulator 15 Pin (tool)
1 HP oil pump 94931 4 Water guide jacket (lower part) 16 Shut-off valve servo oil
1 Hydr. distributor 94934H 5 Lubricating quill (items 6 to 8) 17 Venting valve servo oil
(with pr. gauge 0...25 bar) 6 Nozzle tip 18 Venting valve lube oil
1
Connection nipple (G¼”)
94934I 7 Holder 19 Pipe bracket
1 HP hose 94935 8 Non-return valve 20 Stop valve
9 Screw
10 Screw-in union
11 Angle union
12 Lubricating oil pipe DF Sealing surface
1. General
If the lubricating quill (items 6 to 8) must be removed with cylinder liner in situ, the
cylinder cooling water must not be drained.
In order to remove a cylinder liner 1 however, it is recommended to remove first all
lubricating quills, whereby the cylinder cooling water must be drained on the
relevant cylinder (see 2708−1 ’Removal of cylinder cover’).
Remark: For the handling of stop valve 20 see detailed instructions in the Operat-
ing Manual 7218−1.
A
WCH01024
9
10
12
11
19
4
20
1
2
3
Lubricating Quill
Removal and Fitting with Pulse Jet Lubrication
Pulse Jet / 2013
To Next Page
Loading...
