Maintenance
6545−1/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
3/ 3
3. Dismantling
For dismantling works and maintenance of the auxiliary blower, please comply
with the instructions of the manufacturer.
The impeller is statically and dynamically balanced, and therefore must in no way
suffer damage. The impeller must be rebalanced in case of any damaged or re-
placed parts turning together with the motor shaft.
4. Fitting
⇒ Fit both centring studs 94652.
⇒ With the aid of trolley 94651C and spur-geared chain block 94650 fit electric
motor 1 including impeller 4 into spiral casing 3 and firmly tighten screws 7
crosswise.
⇒ Remove centring stud and replace it by screws.
⇒ Connect electric motor to mains and check direction of rotation.
2013
Auxiliary Blower: Maintenance
To Next Page
Loading...
