Maintenance
6606−2/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
3/ 6
⇒ Mount pin 94665 and roller 94665A on the corresponding support as shown in
Fig. ’C’. Lock pin with its double spring clip 15.
⇒ Fasten manual ratchet ’H1’ to the upper support 16 and connect it to cover 1
via roller 94665A.
⇒ Loosen screws to cover 1, lower it to bottom plate and and push it to the side.
⇒ Remove vent pipe 6 and drain pipe 7.
⇒ Remove cooling water inlet pipe 8 and cooling water outlet pipe 9 between
connection chamber 3 and butterfly valve 10.
⇒ Loosen screws 5 of the screw connection to tube stack 12 for scavenge air
receiver 4 (Fig. ’A’).
⇒ Fix roller plate 94662(A) at connection chamber 3. Press the rollers a little
against rails 11 by means of setscrews ’ST’ (Fig. ’C’).
⇒ Loosen the tube stack from the scavenge air receiver with the aid of jack
screws. As soon as the tube stack is free, lift it a little by tightening setscrews
’ST’.
C
AH
a, b
010.571/02
ba11
FIXED SIDE
ZS
I
II
94662(A)
3
I
94665 94665A15
16
II
III
III
010.570/02
3TR 12
1
II
ST
2013
Scavenge Air Cooler: Removal and Fitting of Tube Stack
To Next Page
Loading...
