Maintenance8460−1/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
2/ 3
⇒ Loosen screws 6 by several turns.
⇒ Undo screws 7 and push flange 8a back until it is no more engaged.
⇒ Push hydraulic pipe 1 back in axial direction and turn it to the side.
⇒ Connect the hydraulic pipe to the crane, undo screws 6 and remove the hy-
draulic pipe.
D Do not damage the sealing faces ’DF’ when removing the hydraulic pipe!
D Close off all openings after removing the connections.
1.1 Checking claw position
⇒ Prior to fitting the hydraulic pipe, check if the
claws 9 are screwed on properly according to
Fig, ’C’, i.e. the hydraulic pipe must protrude
by ’x’ = 6 mm compared to the claw.
D Adjust distance ’x’ by turning the claw by
means of an open-end wrench.
B
C
015.996/07
015.997/07
1
LB
1
11
6
8
12
DF
8, 8a
10
9
11
X = 6 mm
11
7
8a
12
DF
I - I
II - II
10
2013
Hydraulic Pipe: Removing, Fitting and Regrinding
To Next Page
Loading...
