Maintenance3303−2/A1
Winterthur Gas & Diesel Ltd.
6/ 7
7. Bottom Bearing Shell −
Installation
1) Attach the four eye bolts (94045-M8,
Fig. 11) to the bearing shell (3).
2) Attach the chain (94327) to the four eye
bolts (94045-M8).
3) Lift the bottom bearing shell (3).
4) Clean the seating surface of the
bearing cover (3) and the bearing
shell (5).
5) Apply a small quantity of clean oil to the
surface of the bearing shell (5).
6) Attach the bearing shell (5) to the
bearing cover (3) with the four screws
(6).
Note: Make sure that the distance
between each end of the bearing
shell and the connecting rod rod is
the same.
7) Remove the chain (94327) and the four
eye bolts (94045-M8).
8. Bearing Cover −
Installation
1) Attach the chain (94019B, Fig. 12) to
the gallery.
2) Attach the manual ratchet (H4) to the
chain (94019B) and the eye bolt on the
bearing cover (1).
3) Move the bearing cover (1) into the
crankcase.
4) Attach the manual ratchets (H2, H3) to
the column and the bearing cover (1).
5) Remove the manual ratchet (H4).
6) Operate the manual ratchets (H2 H3) to
lift the bearing cover (1) into position.
2015
Bottom End Bearing − Removal, Inspection and Installation
Fig. 11
6
6
94327
3
94045-M8
5
WCH02423
EXHAUST SIDE
H3
H4
94019B
H2
1
WCH02423
FUEL SIDE
Fig. 12