OPERATION (Not ‘HL’ Model) 12
the operating lever and gently bring the skip back onto to stops. This
is particularly important if you have not completely emptied the skip.
Allowing the skip to return onto the stops with force will damage the
machine.
Holding the lever to the rear until the skip is fully lowered will cause
the relief valve located in the control valve to ‘blow off’ allowing the
oil to return to tank. Do not continue to hold the lever rearward when
the ‘relief valve’ blows off, this will cause the hydraulic oil
temperature to increase and may cause damage to components.
Once the skip is seated on the stops release the operating lever to
the neutral position.
To Next Page
Loading...
