EasyManuals Logo

Winnebago 2013 Adventurer User Manual

Winnebago 2013 Adventurer
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
SECTION 7 –
PLUMBING
7-18
2. Close door. Advance Cycle Selector to “B”.
3. Press ON/OFF button, then press START. Let
the Washer/Dryer run for 1 to 2 minutes.
4. Press ON/OFF button to turn power OFF.
5. Unplug Washer/Dryer from electrical outlet
(or disconnect power).
6. Turn Water Supply Faucets OFF. Disconnect
inlet hoses from faucets.
7. Drain remaining water from hoses. Finished.
To use Washer/Dryer again after seasonal
storage:
1. Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON.
NOTE: Check water inlet hoses and pump
periodically (see manufacturers user
guide for further information).
2. Plug Washer/Dryer into electrical outlet (or
reconnect power).
3. With Washer/Dryer power OFF, pour 1/2
TBSP. of powder detergent (or liquid
equivalent) into “Compartment 2” inside
Dispenser Drawer.
4. Advance Cycle Selector to “Position 4”.
5. Press ON/OFF button, then press START.
6. Allow machine to run through the complete
cycle to clean out any remaining antifreeze.
Finished.
Method 2 – Fill with RV Antifreeze
If you have decided to fill the coach waterlines
with RV antifreeze, follow these steps to
winterize your Washer/Dryer:
1. With machine power OFF, advance Cycle
Selector to “Position 3”.
2. Press ON/OFF button, set water temperature
to WARM, then press START. Let machine
fill until the drum turns (this could take up to
1 to 2 minutes).
3. Press ON/OFF button to turn power OFF.
4. Advance Cycle Selector to “B”.
5. Press ON/OFF button, then press START.
6. After letting antifreeze drain completely from
drum, press the ON/OFF button to turn power
OFF. Finished.
To use Washer/Dryer again after seasonal
storage:
1. Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON.
NOTE: Check water inlet hoses and pump
periodically (see manufacturers user
guide for further information).
2. Plug Washer/Dryer into electrical outlet (or
reconnect power).
3. With Washer/Dryer power OFF, pour 1/2
TBSP. of powder detergent (or liquid
equivalent) into “Compartment 2” inside
Dispenser Drawer.
4. Advance Cycle Selector to “Position 4”.
5. Press ON/OFF button, then press START.
6. Allow machine to run through the complete
cycle to clean out any remaining antifreeze.
Finished.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Winnebago 2013 Adventurer and is the answer not in the manual?

Winnebago 2013 Adventurer Specifications

General IconGeneral
BrandWinnebago
Model2013 Adventurer
CategoryMotorhomes
LanguageEnglish

Related product manuals