Winnebago Adventurer 35F User Manual

7-11
SECTION 7 -
PLUMBING
Waste Pump
The 12-volt Waste Pump disposes black
holding tank waste (for the front toilet) through a
small diameter sewer hose, which is then drained
through the main sewage drain outlet.
NOTE: If Waste Pump stalls, check breaker in
the load center. If problem persists,
remove end cap and manually turn pump
shaft (located on the end of the waste
pump) with a screwdriver.
Further Information
For complete operating instructions and
troubleshooting tips, see the Waste Pump
manufacturer’s user guide provided in your
InfoCase.
Dumping Holding Tanks
1. Remove sewage drain hose from water
service center.
2. Remove dust cap from sewage drain outlet
and connect sewage drain hose. Be sure it is
firmly attached.
3. Place the outlet end of sewage drain hose into
disposal opening.
4. Open the Front Black Waste Tank Drain
Valve #1 (located in passenger side
compartment ahead of the rear axle).
5. Open the Front Black Waste Tank Drain
Valve #2 (located in water service center).
Waste Pump
(Located in passenger side
compartment ahead of rear axle)
-Typical installation shown
Sewage Drain Hose
-Typical View
Sewage Drain Outlet
(Located in water service center)
-Typical View
Black Waste Tank Drain Valve #1 (Front)
(Located in passenger side
compartment ahead of rear axle)
-Typical View

Winnebago Adventurer 35F Specifications

General

Make	Winnebago
Model	Adventurer 35F
Fuel Type	Gasoline
Horsepower	350 HP
Torque	468 lb-ft
Transmission	6-speed automatic
Air Conditioning	Yes
Chassis	Ford F53
Category	Motorhome
Exterior Width	8 ft 5.5 in
GVWR	22, 000 lbs
Generator	Onan 5.5 kW
Fuel Capacity	80 gallons