5
B) 7-WAY ROUND PLUG MOUNT
This installation is based on powering the Camera over the 7-way round outlet. When installed as
directed, the camera image will only appear when the vehicle is in reverse.
Caution: This unit is designed to operate on a 12V/24V DC NEGATIVE GROUND electrical system.
Connecting to other types of electrical systems will cause damage to your vehicle. Please contact
the manufacturer if you are unaware of the system type in your vehicle.
1. Locate the 7-way trailer outlet.
2. Match for the orientation and plug in the adapter generally. (Fig.1)
3. Turn the camera o by using the on/o button on the top of the camera before mounting to the
adapter. The camera will power on when your vehicle is in reverse.
4. Mount the wireless camera on the adapter. If the mount camera is not horizontal due to outlet
orientation, rotate clockwise or anti-clockwise to have the desired angle. (Fig.2)
5. The monitor will automatically start when connected to a power source. If when you place
the vehicle in reverse there is no image, go to the section “Settings and Operation” for more
information.
6. As a last check, note the position of the view from the Camera when you place the vehicle in
reverse. Adjust the angle of the Camera as necessary to achieve the best rear view.
Fig.1
Fig.2
To Next Page
Loading...