Need help?Do you have a question about the Winson WNI-6712 and is the answer not in the manual?
Describes the process of setting up the barcode scanner using setting barcodes.
Details the format for setting command data, including prefix, goals, type, and parameters.
Explains the commands for entering setting mode and saving/exiting settings.
Provides commands and descriptions for pairing the wireless barcode scanner.
Details multi-language settings for HID-KEYBOARD mode, including country-specific codes.
Scans and transfers data, with fail alarm; includes buffer for failed transmissions.
Increases buffer data after transmission failure, automatically uploads cached data.
Automatically stores barcode data, uploaded once after scanning 'Upload Data'.
Sends data to receiver or PC; data is stored until [Clear Data] is scanned.
Configures uppercase key detection and numeric keyboard behavior for output.
Sets output formats like GBK and Unicode, and configures function key suffixes.
Configures scanner sleep timer durations: 1, 5, 15, 45 minutes, or non-sleep.
Restores all scanner settings to their original factory defaults.
Filters out 0x0A (newline) characters in the middle of strings.
Disables the filtering of 0x0A characters, allowing them to be output normally.
Configures the scanner for USB output interface.
Sets up USB Virtual COM Port (VCP) output, requiring driver installation.
Configures RS232 serial port output, optimizing transmission for new products.
Enables the infrared induction trigger for automatic scanning.
Disables the infrared induction trigger.
Instructions for upgrading firmware on receiver and sender units.
Enables or disables wireless connectivity testing for scanners connected to a receiver.
Enables USB wired output for direct transmission via USB cable.
Sets the baud rate for serial port communication (e.g., 9600, 115200).
Configures the data length for serial port communication (e.g., 7 or 8 data bits).
Sets the stop bit for serial port communication (e.g., 1 or 2 stop bits).
Configures the parity bit for serial port communication (e.g., None, Odd, Even).
Configures no start symbol or custom start symbol and barcode for data transmission.
Configures no suffix or custom suffix composed of ASCII codes for data transmission.
Enables or disables prompt sounds for successful code reading and wireless transmission.
Details status indicators, LED states, and buzzer announcements for the receiver.
Defines the packet format for 2.4G wireless data transmission using bk2425.
Details the storage format for inventory management, including sequence, barcode count, and cache count.
General| Image Sensor | CMOS |
|---|---|
| Type | Handheld |
| Interfaces Supported | USB |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 5% to 95% (non-condensing) |
| Decode Capability | 1D |
| Supported Barcodes | UPC, EAN, Code 39, Code 128 |
| Operating Voltage | 5V DC |
To Next Page