What to do if Wisenet Baby Monitor screen is frozen?
If your Wisenet Baby Monitor screen is frozen, try restarting the monitor and verify the connection to the camera. Should the monitor display an "Out of Range" message, decrease the distance between the monitor and the camera.
Why is the picture choppy on my Wisenet BabyView Eco PT SEW-3049W?
If you're getting a choppy picture on your Wisenet Baby Monitor, it might be due to a lower frame rate. Here's what you can do: 1. Try positioning the camera closer to the monitor. 2. Clear any obstructions that might be between the monitor and the camera. 3. Adjust the monitor's antenna to a vertical position.
Why is my Wisenet BabyView Eco PT SEW-3049W Baby Monitor emitting high pitched noise/feedback?
If your BabyView Eco PT by Wisenet is emitting a high-pitched noise or feedback, try moving the units further apart. This should eliminate the noise.
How to fix no picture from camera on Wisenet BabyView Eco PT SEW-3049W?
If you're not getting any picture from the camera on your Wisenet Baby Monitor, here are a few things to check: 1. Ensure all connections to the camera are secure and the adapter is properly plugged in. 2. Verify that both the cameras and the monitor are powered ON. 3. Confirm that the camera is within the monitor's range. 4. Ensure the camera and monitor are correctly paired. 5. Adjust the monitor antenna to a vertical position.
What to do if no sounds on Wisenet BabyView Eco PT SEW-3049W Baby Monitor?
If you're not hearing any sounds from your Wisenet Baby Monitor, even with both units turned on, consider the following: 1. Check that the power adapter is securely connected to the camera. 2. Ensure the monitor is charged using the included adapter, as the battery may be depleted. 3. Confirm that the monitor is within the camera's operational range.
General| Night Vision | Yes |
|---|---|
| Two-Way Talk | Yes |
| Zoom | Digital Zoom |
| Camera Resolution | 720p HD |
| Power Source | AC Adapter |
| Operating Temperature | 0°C to 40°C |
Device compliance with FCC rules, subject to two conditions regarding interference.
Equipment tested for Class B digital device limits, providing protection against harmful interference.
Changes not approved by the compliance party could void authority; transmitter must not co-locate with others.
Device compliance with RSS-247, subject to two conditions regarding interference.
Equipment complies with IC radiation exposure limits for uncontrolled environments, min 20cm distance.
Key safety warnings including strangulation hazard, small parts, supervision, and electrical precautions.
Instructions for fully charging the monitor and connecting the camera and monitor.
Procedure to pair additional cameras with the monitor, including steps and countdown.
Instructions for placing the wireless monitor, including using its stand.
Guidance on planning camera placement, routing cables, verifying performance, and mounting.
Warnings about camera aiming, placement near obstructions, and strangulation hazards.
To Next Page
