8.1.3 Add multiple IPTV input
Go to Inputs, click ADD NEW INPUT. Select IPTV in the drop down list for Input type list.
Select Creation mode Multiple. The output names will be auto created.
1. Select Property to increment: Multicast address or Port.
2. Select Bitrate mode:
a. CBR Automatic (auto-detects the incoming constant
bit rate)
b. CBR Manual (manual setting of constant bit rate in)
c. VBR (Variable bit rate in)
3. Select Network interface. If no network interface is available,
you can use the link Manage interfaces. More information
about Network Interfaces are given in §13.1
4. Select Routing scheme, Multicast or Unicast:
a. For Multicast; enter the Multicast address and Port
b. For Unicast: enter the Port (address will be the same as the IP address of the streaming interface)
5. Click the “yellow tick” to save the settings.
Input status and edit settings
If your settings were OK, the status will not indicate any error. Expand the input by clicking the in front of the
input name to see further information. Click the in front of Settings to edit settings.
To Next Page
Loading...
