Wisi Chameleon - Add Tuner Inputs

©WISI Communications 2015, Subject to technical changes and misprints
20
www.
www.wisi.de
8.2 Add tuner inputs
Adding tuner inputs
1. Go to Inputs and click on ADD NEW INPUT.
2. Select TUNER in the Input type list.
3. Type a name for your input.
4. Select the Physical port from the drop down list. Port 1 is the top F-
connector (RF in 1), port 2 is the lower F-connector (RF in 2), see
picture in §9.1.
5. Select tuner input type in the Configuration drop-down list.
6. Fill out the required settings and click the “yellow tick” to
save the settings.
Note that each input type has its own set of input settings. Below some
examples are given.
DVB-T and DVB-T2 input settings:
 Name [type a name]
 Physical port [RF 1, RF 2]
 Frequency table [CCIR, OIRT]
 Frequency (MHz) [select channel, or enter frequency]
 Bandwidth [6 MHz, 7 MHz, 8 MHz]
For DVB-T2:
 Bandwidth [5 MHz, 6 MHz, 7 MHz, 8 MHz]
 PLP [Automatic, Manual]
o PLP ID [enter PLP ID]
DVB-C input settings:
 Name [type a name]
 Physical port [RF 1, RF 2]
 Frequency table [CCIR, OIRT]
 Frequency (MHz) [select channel, or enter frequency]
 Symbol rate (kBaud) [enter the symbol rate]
 Constellation [Auto, 16QAM, 32QAM, 64QAM,
128QAM, 256QAM]
DVB-S and DVB-S2 input settings:
 Name [type a name]
 Physical port [RF 1, RF 2]
 Transponder frequency (MHz) [enter tp frequency]
 Symbol rate (kBaud) [enter the symbol rate]
 LNB type [Universal, Fixed, C-band]
 Polarisation [Horizontal, Vertical]
 Switch type [None, DiSEqC switch]
o Switch port [1, 2, 3, 4]
The available tuner input types
will depend on the Software
Options, and on your HW.
Example of DVB-C input settings
Example of satellite input settings
Example of DVB-T input settings