Wisi Chameleon - Add and Configure ASI, SDI, HD-SDI and FM Outputs

©WISI Communications 2015, Subject to technical changes and misprints
29
www.
www.wisi.de
9.5 Add and configure ASI, SDI, HD-SDI and FM outputs
Add ASI outputs
1. In the Output, select ASI in the drop down list for
Output Type
2. Enter Name, Physical port and Bitrate
3. Select Byte mode [188 byte, 204 byte]
4. Click the “yellow tick” to save the settings.
Add and configure SDI outputs
Select PAL-625/SECAM Operation Mode in Settings, then
click ADD NEW OUTPUT under Outputs.
1. In the Output, select SDI in the Output Type list
2. Enter Name and select Decoder instance
3. Select Video standard
4. Click the “yellow tick” to save the settings.
5. Go to Service Management
6. Add a service to the SDI output
7. Settings for audio language and subtitling are the same as
for analogue outputs
Note: only DVB subtitling can be added as subtitles
SDI outputs Advanced settings
Under Advanced settings for SDI outputs you
can select OSD Test pattern ON/OFF, and SDI
out Stereo mode:
 Stereo
 Dual mono
 Dual laft
 Dual right
 Dolby Pro Logic II
The Dolby Pro Logic II stereo mode includes (if present) information from surround channels to the stereo output.