9.8 Add and configure IP FEC outputs
IP FEC out requires Software Option GNSTREC, and is available only in Operation Mode Streaming FEC mode.
Configure a network interface for streaming (see also §12.1)
1. Go to Networking in the Settings tab, and select Add interface.
– For GN01 or GN40 mounting, add a new network interface for the streaming port.
– For GN50 mounting, add a new network interface to the backplane port.
2. Enter name for the interface, and IP parameters
3. Select Streaming ON, and click the “yellow tick” to save the settings
Add RTP + FEC IP output
1. Select operation mode Streaming FEC mode under SETTINGS
2. In the Output, select IPTV in the drop down list for Choose output type
3. Select Create mode [Singel, Multiple]
4. Enter a name for the output
5. Select Protocol RTP+FEC
6. Select FEC L dimension (column) and FEC D dimension (row)
7. For protocol RTP+FEC, only bit rate mode CBR is available
8. Set the output Bitrate (Mbit/s)
9. Set the Time to live (hops). The default TTL=255 => no limit for the lifespan of data.
10. Select Network interface
11. Set the Destination address and Port.
12. Click the “yellow tick” to save the settings
To Next Page
Loading...
