Output (TS) settings (remuxed)
The transport stream (TS) DVB Network settings can be
accessed by selecting Edit in the pop up menu, or by clicking
the in front of Settings at the output level. TSID, ONID,
Network ID, Network name and LCN types can be edited. More
information about the DVB Network settings in §10.9.
The pop-up menu at Outputs or Transport streams level allows you to edit the TS
DVB Network settings (see above), remove all services from an output, add an EMM
connection (see §11), and set the Character encoding (see §10.4.3).
Output level pop-up menu (transparently connected)
The pop-up menu at Outputs or Transport streams level of an output that is transparently
connected from an input allows you to disconnect the transparent connection or edit the
Network ID (NID). Note that editing the NID is possible only if you have selected Share NIT to ON
under Setting.
Note: there are 2 different ways to edit the DVB
Network settings for an output:
■ Select Edit in the Output level pop-up menu
■ Navigate to the Settings under an output, and select
Edit for this menu, see the following page
These 2 menus have different layout, but contain the
same information, except that the Network name
entry is not available from the Output level pop-up
Edit.
To Next Page
Loading...
