10.4.2 Advanced management of tables and streams in Outputs
The Service Management includes advanced management of tables (PSI/SI tables) and streams (ranging from EMM
and ECM streams to elementary streams such as audio streams or video streams). This enables a wide range of
advanced applications, where the user is assumed to have thorough knowledge of how to manage the tables and
streams.
Please note that using this functionality also adds the possibility to create
configurations that will not be according to standard application, and hence
potentially can create problems in a network. It is advised to contact Support if
there are any doubts about correct settings or applications.
Advanced application example
This user manual will not cover all settings and applications for the advanced settings. As one example of possible
usage of the advanced settings, you can create a service in an output without adding a service from the Input part
of Service Management.
For specific use cases, please contact Support for help or further
documentation.
PSI/SI table management
All PSI/SI tables are listed under the PSI/SI table entry, and can be
displayed by clicking the arrow in front of the entry line. The
general pop-up menu is allows you to edit the table settings
(enabled On / OFF, table repetition rate), or reset to the default
values. For most tables, you can also create descriptors and/or
block incoming descriptors.
As an example of PSI/SI table management, all the EIT Actual
Schedule and EIT Other Schedule tables can be enabled or
disabled, allowing you to modify the “EPG” data transmitted.
For specific use cases, please contact Support for help or further
documentation.
To Next Page
Loading...
