Wisi Chameleon - Outputs TS DVB Network Settings; Outputs Services Settings

©WISI Communications 2015, Subject to technical changes and misprints
57
www.
www.wisi.de
10.9 Outputs TS DVB Network settings
TSID, ONID, NID, LCN type and
Network Name
Each outgoing Transport stream (TS) has a set of
identifiers: TSID (transport stream ID), ONID (original
network ID), NID (network ID), LCN (logical channel
numbering type) and Network Name. All identifiers can be
edited by clicking menu icon, , and select Edit.
TSID
The transport_stream_id (TSID) is a 16-bit field which
serves as a label for identification of this TS from any other
multiplex within the delivery system. Hence, the TSID has
to be unique within a DVB Network.
ONID and NID
The SI uses two labels related to the concept of a delivery system, namely the
network_id (NID) and the original_network_id (ONID). The latter is intended to
support the unique identification of a service, contained in a TS, even if that TS
have been transferred to another delivery system than the delivery system where
it originated.
Network Name
A string of characters that specify the name of the delivery system about which the NIT informs.
A change of the Network Name is propagated to all TS with the same NID.
LCN (LCN type)
The LCN type specifies which LCN implementation to use. For a DVB Network, the LCN
type should be the same for all outgoing muxes. Please note that you can add several
LCN types for each transport stream out without any conflict in the descriptors in the
PSI/SI structure, but you still have to check that the receivers in the network can handle
input signals with several LCN types.
Available LCN types are Nordig, EACEM and ITC (Independent Television).
10.10 Outputs services settings
Service name, service provider name, service ID,
LCN number, HD-LCN, PMT PID, PCR PID, Type and
Running status
Each service in an outgoing transport stream has a set of
identifiers: service name (Name), service provider name
(Provider), service ID (SID), LCN number (LCN) and HD-LCN.
These identifiers are listed for all output services. All
identifiers can be edited by clicking menu icon, , and
select Edit. PMT PID, PCR PID, service type (Type), and
Running status can be set or selected.
The LCN number is
edited in the settings
for each service.
If no network_id (NID) is set,
the outputs will not contain
any NIT.