11.6 Edit Group in SCG (set up connection to ECMg)
Scrambling Control Group (SCG) (ETSI TS 103 197 V1.5.1 ): data structure gathering together in one same logical set
the list of A/V streams scrambled at the same time with the same control word and the list of ECMs that are going
to be generated with the identifier of their CA system and with their respective Access Criteria
After adding an SCG, edit the group to set up connection to an EMMg.
1. Set ENABLED to ON
2. Enter an ECM ID (You can select any numerical value, but commonly a CAS will require that the ECM ID is the
same for all (scrambled) outputs in your DVB network.)
3. Select how to enter the ACCESS CRITERIA: HEX or ASCII
4. Enter the ACCESS CRITERIA (info from CAS supplier)
5. Optionally: enter private data
6. Click the “yellow tick”
Status at this stage (before any service is connected to the Group in Service Management)
In the Group header: “No services connected”
Under the Group:
■ Status No services connected
■ Scrambling status Scrambling
■ Current crypto period 235 (increasing with new CW being created)
To Next Page
Loading...
