NTP server connection for UTC time reference
In the DATE AND TIME menu under SETTINGS, click the menu icon, , and select Edit.
1. Select your Time zone in the drop down list
2. Select daylight saving time ON/OFF
3. Enter a valid URL to an NTP server (e.g. ntp.pool.org)
4. Click the “yellow tick” to save
The added NTP server will be shown under Time sources. The UTC time from the NTP server is displayed, and if
there are other valid time sources, their times will also be displayed.
As default, the NTP time reference is used for the TDT.
Selecting Time source for the TDT manually
1. Click the menu icon, , to the right of the Time source that is indicated as YES under USED, and select
Edit.
2. Select OFF under ENABLED
3. Click the “yellow tick” , or click enter
The Time reference will automatically switch to another Time source.
12.3 Scheduler – commands scripting
The Scheduler is a task scheduler that can be used to run LUA commands from the UI of the Chameleon. The
triggering of the tasks (set of commands) is based on local time date and time, with the time source in Date and
Time as reference.
The Scheduler can be set up to run tasks daily, weekly, monthly, yearly or once. The Enable ON/OFF gives you the
possibility to save tasks without executing them.
To Next Page
Loading...
