SNMP versions supported
In the current implementation, SNMP version 1, SNMP version 2c and SNMP version
3 is supported.
SNMP settings
■ Enable agent: for turning the SNMP agent in Chameleon ON/OFF
■ Agent port: UDP listen port (161 is the standard port used)
■ Agent security level: controlling authentication and encryption.
When “No authentication or encryption” is selected:
Agent community read string: a “password” that has to be set in the NMS. The standard default string is
“public”.
Agent community write string: a “password” that has to be set in the NMS. The standard default string is
“private”.
■ Enable traps: for turning ON/OFF the alarm (traps) functionality
■ Traps SNMP version: selection of used SNMP version
■ Traps community read string: a “password” that has to be set in the NMS. The standard default string is
“public”.
■ Traps PDU: selection of SNMP Protocol Data Units (PDU); Trap / Inform
For the TRAP DESTINATIONS
■ Dest. address: destination address of the NMS receiving the trap
■ Dest. port: destination port of the NMS receiving the traps
Supported traps and SNMP read/write in software 2.4.3
A complete description of all SNMP traps and read/write is listed in a separate document. Please contact
Support for more information.
■ IP input changed alternative input (for input
redundancy)
■ Chameleon temperature exceeding 65 °C
■ Video decoder not running
■ FM decoder running / not running
■ PAT on input timed out
■ Simulcrypt EMMg connected/disconnected
■ Simulcrypt ECMg connected disconnected
■ Tuner input configuration
■ IP input status
■ IP input configuration
■ Chameleon module temp. (read only)
■ Chameleon module name (read only)
■ Chameleon module description (read only)
■ GN50 slot number (read only)
To Next Page
Loading...
