Need help?Do you have a question about the Wisi GT 01W Tangram and is the answer not in the manual?
Precautions for handling electrostatic sensitive devices to prevent damage during unpacking, installation, and use.
Identifies ports and components on the front panel of the GT22 module, including RF and control ports.
Describes the process of installing GTxx modules into the Tangram chassis, noting hot-swappable features.
Details the RJ-45 and SFP Ethernet ports on the front of the Tangram, including numbering and grouping.
Explains the rear module slots and the port layout of the GT22 module.
Covers connecting to the Tangram Web UI and initial network settings.
Discusses the main control page, status monitoring, and maintenance for GT11/12 switch modules.
Details module tabs, status, settings, and redundancy configuration for the internal switch.
Explains port grouping and VLAN ID distribution for managing video traffic.
Covers connecting to modules, adding IP addresses, and general module setup.
Guides on registering Tangram modules and downloading SW options via the WISI Tangram portal.
Details adding inputs, configuring paths, redundancy, and IGMP settings.
Describes setting up FM outputs, including edge decoder adjustments and service selection.
Shows available inputs, outputs, and service IDs with PIDs in the Service Management tab.
Covers network interface configuration, date/time sync, SNMP, and user management.
Details uploading software/entitlement files and module maintenance operations like reboot and reset.
Provides a general overview of the Tangram module via the Status tab, including identification and configuration.
Explains the meaning of different LED states and indications on the GT22 master board.
Provides contact information for support and links for user manual and installation guide updates.
To Next Page
General