To Next PageTo Next Page
Need help?Do you have a question about the WITTUR sematic SDS Rel. 3 and is the answer not in the manual?
General| Brand | WITTUR |
|---|---|
| Model | sematic SDS Rel. 3 |
| Category | Controller |
| Language | English |
Explains the opening and closing speed profiles of the door operator.
Details supply voltage, power consumption, temperature, and humidity ratings.
Identifies the Sematic Drive System Door Controller and its components.
Illustrates the wiring diagram for the DC-PWM controller.
Explains direct connection of photocell relay contacts to the controller.
Describes the behavior of the controller in automatic mode.
Details operation and signal ignoring in manual mode.
Explains how to enter and use the programming mode.
Procedure to check if the controller is functioning correctly.
Configuration of reversing system force and offset parameters.
Options for testing interaction with the Main Lift Controller.
Settings for the Kn input, including default, reversal, and safety edge.
Configuration for the optional car door locking device.
How to command low-speed closure when obstacles are detected.
Settings for fire fighting installations and its input.
Configuration for Emergency Opening Device and its timeout.
Logic settings for protective device input Kn.
Options for closing parking mode, including skate parking.
Setting the type of skate used by the operator.
Configuration of signals for managing the IM (reversing motion).
Lists alarm codes, error descriptions, and corrective actions.
Steps to perform a self-learning cycle for the door controller.
Information on connecting and using the optional handset.
Overview of the Door Configuration options accessible via handset.
Details the Maintenance options like monitor and alarms.
Steps to activate the self-learning cycle using the handset.
How to set reversing system force using the handset.
Details the "Parameters" section for speed profiles and other settings.
Navigating MLC and Input parameters using the handset.
Adjusting reversing system and changing the access password.
Procedure to set the skate type for the door operator.
How to select the motor type for the drive system.
Adjusting speed profiles via the handset.
Accessing monitor data, statistics, and alarms from the maintenance menu.
