Wolf CE152TF/S - Page 82

Page 82
Integrated Modules
Integrated Modules
Technical Data
5-6
#826498 - Revision B - November, 2016
Total
Wattage
(± 5%)
1200
Diameter
(inches)
5.5
Cold
Resistance
(± 5% Ohms)
45.6
1200 Watts 240 VAC
Total
Wattage
(± 5%)
1200
Diameter
(inches)
5.5
Cold
Resistance
(± 5% Ohms)
34.3
1200 Watts 208 VAC
Total
Wattage
(± 5%)
700
2200
Diameter
(inches)
4.72
8.11
Wattage
(± 5%)
700
700
Cold
Resistance
(± 5% Ohms)
78.2
78.2
Wattage
(± 5%)
--
1500
Cold
Resistance
(± 5% Ohms)
--
36.5
Zone 1 Zone 2
2200 Watts 240 VAC
Total
Wattage
(± 5%)
700
2200
Diameter
(inches)
4.72
8.11
Wattage
(± 5%)
700
700
Cold
Resistance
(± 5% Ohms)
58.9
58.9
Wattage
(± 5%)
--
1500
Cold
Resistance
(± 5% Ohms)
--
27.5
Zone 1 Zone 2
2200 Watts 208 VAC
CE - Element Assembly Wattage, Diameter, and Resistance
CE152TF/S - Element Temperature Built-in Thermal Limiter
Each element has a built-in thermal limiter to protect the glass top.•
Thermal limiter will open between 1040° F and 1076° F.•
Thermal limiter will close at approximately 950° F.•
SM15TF/S - Temperature Control
Maintain between 80 ounces and 256 ounces of liquid within 1.8°F (1°C) of the set point between the tem-•
peratures of 131°F (55°C) and 185°F (85°C).
Temperature must remain within 1.8°F (1°C) of set temperature after preheat.•
SM15TF/S - Auto Drain
Liquid temperature below 140°F (60°C) - touch and hold DRAIN pad for three seconds. Valve will open for•
two minutes.
Liquid temperature above 140°F (60°C) - touch and hold of DRAIN pad for three seconds results in error•
tone and HOT light and temperature display will flash three times.
FM15TF/S - Temperature Control
Temperature must remain within 5.4°F (3°C) of set temperature after preheat.•
SM15TF/S and FM15TF/S - Thermodisc, Fryer-350 Deg
Opens at 350°F ± 9°F.•
Manual reset. •
Auto close at -31°F.•