Wolf CG365P/S - AC-DC Rectifier Installation

Page 19
Remove All Bezels
To remove each bezel:
Use a
3
/
4
" socket to remove the bezel from the unit.
Remove the Light Module
1 Pull the light module forward out of the receptacle.
2 Disconnect the AC-DC rectifier wire connector from the light
module.
Uninstall the Unit
Remove the unit from the installation.
Remove the AC-DC Rectifier
1 Disconnect the AC-DC rectifier from the unit harness.
2 Cut the wire ties holding the AC-DC rectifier to the manifold.
3
Remove the AC-DC rectifier.
AC-DC RECTIFIER INSTALLATION
Install the AC-DC Rectifier
1 Place the AC-DC rectifier in the unit.
2 Use wire ties to secure the AC-DC rectifier to the manifold.
3 Connect the AC-DC rectifier to the unit harness.
Install the Unit
Install the unit.
Install the Light Module
1 Connect the AC-DC rectifier to the light module.
2 Insert the tabs of the light module into the receptacle.
3 Push the light module into the receptacle.
Install All Bezels
To install each bezel:
1 Insert the bezel into the unit.
2 Use a
3
/
4
" socket to install the bezel on the unit.
Install All Knobs
Push each knob onto each valve shaft.
CG Contemporary Gas Cooktop Service Manual
service.subzero.com
828389 REV. A 06/2018
18