wolfappliance.com
|
17
TROUBLESHOOTING
Troubleshooting
OPERATION
Coffee system does not operate.
• Verify power is on.
• Verify electrical power to unit and home circuit breaker
is on.
Infuser is difcult to reinstall.
• Before inserting, compress top and bottom ends of the
infuser together to adapt to the proper dimension for
installation.
• Once inserted, verify two red buttons have snapped out.
‘LESS COFFEE’ message displayed.
• Too much coffee has been used. Select a milder tasting
coffee or reduce the quantity of pre-ground coffee.
‘EMPTY CIRCUIT FILL CIRCUIT’ message displayed.
• The water circuit is empty. Connect the hot water nozzle
and press
to deliver water from it, until it ows out
normally.
‘GENERAL ALARM’ message displayed.
• Interior needs thorough cleaning. Refer to page 16.
If message displays after cleaning, contact Wolf cus-
tomer care at 800-222-7820.
COFFEE QUALITY
Coffee not hot enough.
• Preheat cups with hot water.
• Change temperature in extended options.
Coffee does not have enough crema.
• Coffee ground too coarsely. Refer to grind adjustment on
page 14.
• Verify type of coffee used is for espresso machines.
Extraction time too slow.
• Shorten extraction time by adjusting grind to coarser
pre-ground coffee. Refer to page 14.
Extraction time too fast.
• Increase extraction time by adjusting grind to ner pre-
ground coffee. Refer to page 14.
Coffee does not come out of spouts.
• Clean blocked spouts.
Coffee comes out from around service door.
• Clean blocked spouts and thoroughly clean the coffee
guide.
Water comes out of spouts instead of coffee.
• Clean pre-ground coffee funnel to unblock.
Milk does not come out of milk spout.
• Verify intake tube is inserted in the rubber washer in the
intake tube.
Milk is not well frothed.
• Clean milk container lid.
• Adjust frothing regulator. Refer to page 12.
To Next Page
Loading...
