Wood-mizer Accuset 2 - Setup & Operation; Control Setup

Setup & Operation
Control Setup
2
2-1 AS207doc100119 Setup & Operation
SECTION 2 SETUP & OPERATION
2.1 Control Setup
The Accuset 2 is programmed for operation with Super
model sawmills by default. If your sawmill is a Standard
model, the Accuset needs to be reprogrammed. Follow the
instructions on page 2-8
.
See Figure 2-1. Turn the key switch to the accessory (#3) position. The Accuset control
starts in Manual Mode by default. See the figure below for identification of the control but-
tons and display.
About using the Up/Down Adjustment Buttons: To make adjustments to a setting,
push the Up or Down arrow buttons to scroll to the desired setting. As you push and hold
the up or down buttons, the setting scrolling speed will automatically increase.
In Manual Mode, the up and down arrow buttons have special functions. You can enter
configuration menus by pushing the Up button. Pushing the Down button moves the saw
head to the nearest nominal inch (or centimeter).
About the Toggle button: Use the Toggle button to exit configuration menus and return
to the main menu. Pressing and holding the Toggle button during startup will reset the
Accuset programming to factory default settings. Pressing the Toggle button in Manual
Mode will place Accuset in Reference Mode.
FIG. 2-1
3H0989
6 - 3/4
Modes
Up
Down
Toggle
Increment Settings
Current Blade Height (inches)
Auto-DownManual Auto-Up Pattern