2-1 AS80doc121616 SETUP & OPERATION
SETUP & OPERATION
Machine Start
2
SECTION 2 SETUP & OPERATION
2.1 Machine Start
IMPORTANT! Before starting to use the machine you have
to meet the following conditions:
Fasten the sharpener to a table top using the mounting holes located in the foot
plates.
The sharpener can be operated with a oil vapors exhaust system only.
The machine can be operated under roof only.
The sharpener can be operated only in temperature range from 5
o
C to 40
o
C (41
- 104
o
F), at the humidity of up to 80%.
The oil for cooling the grinding wheel must meet the specifications listed in
Table 1-5 on page 7. Water or other liquids must not be used.
The position of the sharpener’s operator is shown below.
The illumination at the operator's position should be at least 300lx
1
1.. The light source can not cause stroboscopic effect.
To Next Page
Loading...
